Temperature range: -50-110 .
Static current: 35MA, attract current 65MA.
Environmental requirements: -10 ~ 60 Humidity 20% -85%.
Relay output interface is a switch when it working, these two ports are connected.
Resolution: When the temperature is 0.1, the resolution is -9.9~99.9, another temperature segment is 1
Product description
Specifications:
PT100 Cable Length: 50cm
Temperature range :-50-110
Dimensions: 48.5 * 40mm
Temperature control mode: ON / OFF
Control accuracy: 0.1
Hysteresis accuracy: 0.1
Refresh rate: 0.5S
High temperature protection 0-110
Supply voltage: DC 12V
Static current: 35MA, attract current 65MA
Output voltage: DC 12V; Output power: 20A relay
Measurement input: NTC (10K 0.5%) Waterproof Sensor
Environmental requirements: -10 ~ 60 Humidity 20% -85%
How to use:
Connect the power supply and the load, you can supply to the controller.
It displayed a measured temperature.
Press the SET button, the display flashes the temperature;
Press – to set the desired temperature;
After setting press SET to confirm return;
The controller automatically performs the relay by setting off!
Lights, LED status descriptions:
Indicator: Off The relay is switched off, Always indicate the relay is closed.
LED: Shows LL is the sensor open, showing HH is out of range, the thermostat will be forced to close the relay, the display — as high-temperature protection.
Note: Relay output interface is a switch when it working, these two ports are connected.
If not work, these two ports are not connected. Pls know it. !!!!!
